UEE Series
Isolated, High-Density, Eighth-Brick
DOSA Low Pro?le DC-DC Converters
TECHNICAL NOTES
THROUGH-HOLE SOLDERING GUIDELINES
Murata Power Solutions recommends the speci?cations below when install-
ing these converters. These speci?cations vary depending on the solder
type. Exceeding these speci?cations may cause damage to the product. Your
production environment may differ; therefore please thoroughly review these
guidelines with your process engineers.
Wave Solder Operations for through-hole mounted products (THMT)
For Sn/Ag/Cu based solders:
SMT REFLOW SOLDERING GUIDELINES
The surface-mount re?ow solder pro?le shown below is suitable for SAC305
type lead-free solders. This graph should be used only as a guideline . Many
other factors in?uence the success of SMT re?ow soldering. Since your pro-
duction environment may differ, please thoroughly review these guidelines with
your process engineers.
Maximum Preheat Temperature
Maximum Pot Temperature
Maximum Solder Dwell Time
For Sn/Pb based solders:
Maximum Preheat Temperature
Maximum Pot Temperature
Maximum Solder Dwell Time
Input Fusing
115oC.
270oC.
7 seconds
105oC.
250oC.
6 seconds
Certain applications and/or safety agencies may require fuses at the inputs of
power conversion components. Fuses should also be used when there is the
possibility of sustained input voltage reversal which is not current-limited. For
greatest safety, we recommend a fast blow fuse installed in the ungrounded
input supply line with a value which is approximately twice the maximum line
current, calculated at the lowest input voltage.
The installer must observe all relevant safety standards and regulations. For
safety agency approvals, install the converter in compliance with the end-user
safety standard.
Input Reverse-Polarity Protection
If the input voltage polarity is reversed, an internal body diode will become
forward biased and likely draw excessive current from the power source. If this
source is not current-limited or the circuit appropriately fused, it could cause
permanent damage to the converter. Please be sure to install a properly
rated external input fuse .
Input Under-Voltage Shutdown and Start-Up Threshold
Under normal start-up conditions, converters will not begin to regulate properly
until the rising input voltage exceeds and remains at the Start-Up Threshold
Voltage (see Speci?cations). Once operating, converters will not turn off until
the input voltage drops below the Under-Voltage Shutdown Limit. Subsequent
restart will not occur until the input voltage rises again above the Start-Up
Threshold. This built-in hysteresis prevents any unstable on/off operation at a
single input voltage.
Users should be aware however of input sources near the Under-Voltage
Shutdown whose voltage decays as input current is consumed (such as capaci-
tor inputs), the converter shuts off and then restarts as the external capacitor
recharges. Such situations could oscillate. To prevent this, make sure the
operating input voltage is well above the UV Shutdown voltage AT ALL TIMES.
Start-Up Delay
Assuming that the output current is set at the rated maximum, the Vin to Vout
Start-Up Time (see Speci?cations) is the time interval between the point when
the rising input voltage crosses the Start-Up Threshold and the fully loaded
regulated output voltage enters and remains within its speci?ed regulation
band. Actual measured times will vary with input source impedance, external
input capacitance, input voltage slew rate and ?nal value of the input voltage
as it appears at the converter.
These converters include a soft start circuit to moderate the duty cycle of the
PWM controller at power up, thereby limiting the input inrush current.
The On/Off Remote Control interval from inception to Vout regulated
assumes that the converter already has its input voltage stabilized above the
www.murata-ps.com/support
MDC_UEE_Series.C01 Page 24 of 29
相关PDF资料
UEI15-050-Q12P-C CONV DC/DC 15W 5V 3A
UEI25-120-D48PM-C 36-75VIN 12VOUT 25W POS LOG SMD
UEI30-050-Q48N-C CONVERT DC/DC 30W 5V SNGL NEG
UEP1H470MPD CAP ALUM 47UF 50V 20% RADIAL
UES1V100MEM CAP ALUM 10UF 35V 20% RADIAL
UFG1V470MEM CAP ALUM 47UF 35V 20% RADIAL
UHD1A332MHD CAP ALUM 3300UF 10V 20% RADIAL
UHM0J102MPD3 CAP ALUM 1000UF 6.3V 20% RADIAL
相关代理商/技术参数
UEE-3.3/30-D48P-C 功能描述:DC/DC转换器 99W 3.3V 30A Pos Polarity TH RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
UEE-3.3/30-D48PM-C 功能描述:DC/DC转换器 99W 3.3V 30A Pos Polarity SMT RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
UEE-3.3/45-D48NB-C 功能描述:DC/DC CONVERTER 3.3V 150W 制造商:murata power solutions inc. 系列:UEE 150W 包装:托盘 零件状态:有效 类型:隔离模块 输出数:1 电压 - 输入(最小值):36V 电压 - 输入(最大值):75V 电压 - 输出 1:3.3V 电压 - 输出 2:- 电压 - 输出 3:- 电流 - 输出(最大值):45.5A 功率(W) - 制造系列:150W 电压 - 隔离:2.25kV(2250V) 应用:ITE(商业) 特性:远程开/关,OCP,OTP,SCP,UVLO 安装类型:通孔 封装/外壳:8-DIP 模块,1/8 砖 大小/尺寸:2.30" 长 x 0.90" 宽 x 0.50" 高(58.4mm x 22.9mm x 12.7mm) 工作温度:-40°C ~ 85°C 效率:92% 功率(W) - 最大值:150W 标准包装:21
UEE-3.3-15-D48 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Isolated, High-Density, Eighth-Brick DOSA Low Profi le DC/DC Converters
UEE-3.3-25-D48 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Isolated, High-Density, Eighth-Brick DOSA Low Profi le DC/DC Converters
UEE-3.3-30-D48 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:Isolated, High-Density, Eighth-Brick DOSA Low Profi le DC/DC Converters
UEE-5/30-D48NB-C 功能描述:DC/DC CONVERTER 5V 150W 制造商:murata power solutions inc. 系列:UEE 150W 包装:托盘 零件状态:有效 类型:隔离模块 输出数:1 电压 - 输入(最小值):36V 电压 - 输入(最大值):75V 电压 - 输出 1:5V 电压 - 输出 2:- 电压 - 输出 3:- 电流 - 输出(最大值):30A 功率(W) - 制造系列:150W 电压 - 隔离:2.25kV(2250V) 应用:ITE(商业) 特性:远程开/关,OCP,OTP,SCP,UVLO 安装类型:通孔 封装/外壳:8-DIP 模块,1/8 砖 大小/尺寸:2.30" 长 x 0.90" 宽 x 0.50" 高(58.4mm x 22.9mm x 12.7mm) 工作温度:-40°C ~ 85°C 效率:92% 功率(W) - 最大值:150W 标准包装:21
UEF-AUTOESL-25 制造商:Xilinx 功能描述:UNIVERSITY AUTOESL, 25 LICENSE BUNDLE - Virtual or Non-Physical Inventory (Software & Literature) 制造商:Xilinx 功能描述:AUTOESL 25 LICENSE BUNDLE